ES811-CM
LTE Cat.M1 & NB GPS Tracker
Digital inputs: ignition detection, door on/off detection, flow meter
Digital outputs: buzzer, relay, enable/disable engine starter
Analog input: temperature sensor, fuel level, TDS meter, breathalyzer
Uarts: camera, RFID reader, iButton, temperature/humility sensor, driver license
RS232C: Modbus, temperature sensor
Intelligent engine on/off detection
Driving behavior detection
Trip start and trip end report
Tamper alert
Power saving mode
Storing message
Geofence
Waterproof
OTA (Over-the-air)
Protocol: HTTP/TCP/UDP/SMS/MQTT/DNP3
ES811 is a LTE (Cat.M1 & NB) GPS tracker for vehicle. It reports location information via TCP/UDP/MQTT with configurable intervals.ES811 has max 4 inputs for various types of sensors, max 4 outputs for enabling/disabling vehicle engine starter and UART(or RS232C) for communicating with other complicated sensors.
LTE & GSM Specifications
Operating Band | Cat M1/Cat NB: LTE TDD: B39 (only Cat.M1 support) GSM: GSM850/GSM900/DCS1800/PCS1900 |
General Specifications
Dimensions | 105mm *65mm *26mm |
Weight | 65g |
Battery Capacity | 300mAh |
Input Voltage Range | 6VDC-42VDC |
Power Consumption | -Active mode:<40mA@12VDC -Sleep mode:<5mA@12VDC |
Operation Temperature | -20℃ to 65℃ |
Storage Temperature | -20℃ to 65℃ |
LTE Module | Quectel BG96 |
Antenna | Built-in cellular antenna and GPS antenna |
GPS Specifications
Sensitivity | Tracking:-157dBm |
Position Accuracy (CEP 50) | <2.5m (Open Sky) |
Interfaces
Inputs | 4 |
Outputs | 4 |
A/D | 2 |
UART | 1 |
RS232C | 1 |
Sim Card | Micro SIM(3FF) |
LED Indicators | 2 for GPS and cellular status |
Feature Lists
Tracking | Send GPS information to server with configurable report interval |
Driving Behavior Detection | Report harsh braking,harsh acceleration and impact |
Intelligent Engine On/Off | Detect engine on/off via ignition input or proprietary detecting method by vibration |
Trip Start and Trip End | Report trip start and trip end |
Tamper Alert | Send tamper alert if the power supply is disconnected |
Over Speed Limit Alert | Report over speed limit |
Power Saving Mode | Switch to low-power mode when it detects engine off |
Storing Messages | Store messages if out of cellular coverage |
Geofence | Support circle and polygon geofence setting |
Supported Inputs/Outputs | Support inputs and outputs for ignition detection, door on/off,buzzer,relay and engine on/off control |
Supported Sensors | Support following sensors: temperature sensor, humility sensor, fuel sensor, flow meter, TDS meter, RFID reader, camera, iButton, Modbus, driver license and so on |
Waterproof | IP66 waterproof |
OTA (Over-the-Air) | Firmware can be remotely upgraded |
Communication Protocols | HTTP/TCP/UDP/SMS/MQTT/DNP3 |
